60,000 psi (4,140 bars)

55,000 psi (3,800 bars)

0.30 gpm (1.13 lpm)

15 cycles/min. at max. flow rate

Main Motor: 15 hp / 11 kW (TEFC)

208v / 3 ph. / 60 Hz

230v / 3 ph. / 60 Hz

460v / 3 ph. / 60 Hz

190v / 3 ph. / 50 Hz

380v / 3 ph. / 50 Hz

Motor Speeds:

1800 rpm @ 60 Hz

1500 rpm @ 50 Hz

Controls:

120 VAC / 24 VDC

Safety Shutdown Circuits:

High Oil Temperature

Low Oil Level

Low Water Pressure

1.5 cu. in. (25 cu. cm) Vane Pump

Max. Operating Pressure: 2,500 psi (172 bars)

Cooling Water Flow Rate: 1 gpm (3.78 lpm)

Minimum Inlet Pressure: 30 psi (2 bars)

Optimum Inlet Pressure: 65 psi (4.50 bars)

Quantity / Orifice Diameter

1 ? 0.008 in. (0.20 mm)

2 ? 0.005 in. (0.12 mm)

3 ? 0.004 in. (0.10 mm)

Height: 55 inches (1.40 meters)

Width: 40 inches (1 meter)

Length: 55 inches (1.40 meters)

Proven, heavy-duty, industrial, high-pressure intensifier.

Slow intensifier speed - 15 cycles/minute. This slow speed both reduces the number of pressure spikes in the system and reduces the number of pressure reversals. This slow speed virtually doubles the fatigue life as compared to other waterjet pumps.

One large accumulator insures low pulsations in the high-pressure system.

All high-pressure tubing and fittings are Autoclave.

A control panel monitors the system. 
The control panel includes:

- start/stop button

- emergency shutdown

- motor starter and overload 
  relay in US models.

Highly reliable proximity switches control the sequencing of the intensifier.

Oversized, low-load motor.

Low hydraulic oil pressure - 2500 psi / 172 bars.

A dial compensator allows for simple control of the cutting water pressure.

The oil reservoir has two large access doors for easy maintenance.

There is a full-flow hydraulic oil filter to insure clean oil and protect the system.

The unit has a hydraulic oil cooling system with full-flow oil heat exchanger.

Brass fittings are used on the entire inlet water system to protect against corrosion.